Home
|
News
|
Feedback
|
Check Your Mail
|
Contact Us
|
Site Map
Departments
About the institute
Principal's View
Management
Academics
Activities
Downloads
Campus Recruitments
Achievements
Admissions
Metrology Laboratory
Laboratory Name
Metrology Laboratory
Location of Laboratory
R.No.2207
Area of Laboratory
72 sq.mt.
Laboratory In charge
Prof. S.S.Kuber
Laboratory Resources
NAME OF EQUIPMENT
UTILISATION
Profile Projector
:
Enlargement of object Image for Measurement Purpose
Floating Carriage Micrometer
:
To measure External Screw Thread Parameters
Surface Tester
:
To measure Surface Roughness.
Sine Bar
:
To measure external taper angle.
a) Electronic Comparator
b) Pneumatic Comparator
:
To Check the variables to find out Acceptance of the Jobs.
Dial Gauge Tester
:
To Calibrate the Dial Gauge
Interferometer
:
To Study Fringe Patterns of
Different Surfaces.
Sine Centre
:
To Measure the Half Taper Angle.
SQC Kit
:
To demonstrate different Statistical Analysis Methods.
Vernier Instruments
a) Vernier Caliper
b) Vernier Depth Gauge
c) Vernier height gauge
d) Vernier gear tooth Caliper
e) Digital Vernier caliper .
:
Linear measurements.
Micrometer Instruments
a) External micrometer
b) Internal Micrometer
c) Span Micrometer
d) Micrometer Depth
Gauge
e) Micrometer Bore Gauge
:
Linear measurements
Combination set
:
To check Angle, Straightness of Surfaces.
Mechanical Comparator
:
To check Height Variations.
Straight Edge
:
To check Flatness
Spirit Level
:
To check Alignment
Equipment Under TEQIP
Micro digital readout profile projector.
Auto Collimator & Angle Dekkor set
Tool Maker’s Microscope
Utilization of Laboratory: For T.E., B.E., M.E. Industrial Engineering. Students.
Back
Top
:::| powered by dimakh consultants |:::
